Prepare the wall
It must be clean, dry, free from dampness and in good condition. Repair any cracks or flaking first.
Installation guide
be Tip-Top
Step by step, how to hang it by pasting the wall: the paper goes up dry, with no paste on the back. You can do it yourself or use a professional installer.
It must be clean, dry, free from dampness and in good condition. Repair any cracks or flaking first.
Painted wall
If it is smooth and in good condition, it does not need priming.
Plasterboard
Apply one coat of primer and leave to dry.
Tiles
Fill the joints with filler until the surface is smooth. Leave to dry, remove the dust and apply the primer.
Draw a vertical line using a spirit level or plumb line and decide where to start so that the pattern matches from one drop to the next.
Each drop should be the height of the wall plus 10 cm. Match the pattern with the previous one before cutting and number them on the back in the order they will be installed.
Apply the adhesive with a roller directly to the wall, in a strip slightly wider than the drop. Paste only the area you are about to cover.
Side by side, butt-jointed and without overlapping, matching the pattern. Smooth them out with the smoother from the centre outwards to remove bubbles.
Remove the excess at the top and bottom with a craft knife and ruler. Clean any adhesive that squeezes out of the joints with a damp sponge, without rubbing.
Keep the room ventilated, free from draughts and strong heat, until the adhesive is completely dry.
Format
Roll of 53 cm × 10 m
Approximately 5.3 m² of wallpaper per roll, before trimming.
Cleaning
Washable
With a damp sponge, without rubbing.
Use
Dry rooms
Bedrooms, living rooms, dining rooms and low-traffic areas.